Security Command XRSuper6 Guide d'installation télécharger pdf (Page 7)

Digital Monitoring Products XRSuper6/XR20/XR40 Installation Guide

REVISIONS

XRSuper6/XR20/XR40 Installation Guide Digital Monitoring Products

INTRODUCTION

Panel Specications

1.1 Power Supply

Transformer Input: Wire-in — 16.5 VAC 40 VA, Model 320

Plug-in — 16.5 VAC 40 VA, Model 321

Standby Battery: 12 VDC 7.0 Ah (40 VA transformer charges up to 2 batteries)

Auxiliary Output: 12 VDC at 500mA

Bell Output: 12 VDC at 1.5 Amps

Smoke Detector Output: 12 VDC at 100mA

All circuits inherent power limited

1.2 Communication

Built-in SDLC Digital Dialer communication to DMP Model SCS-1 and SCS-1R Receivers

Built-in 4-2 communication to non-DMP receivers

Built-in M2E (Radionics Modem IIe) communication to non-DMP receivers

Built-in CID (Contact ID) communication to non-DMP receivers

Any panel can operate as a local system.

1.3 Panel Zones

Nine 1k Ohm EOL burglary zones: zones 1 to 9 on XR20 and XR40 panels, and zones 1 to 5 on the XRSuper6.

One 3.3k Ohm EOL Class B powered re zone with reset capability: zone 6 on the XRSuper6, and zone 10 on

XR20 and XR40 panels.

1.4 Keypads

You can connect up to four supervised keypads to the XRSuper6/XR20 panels and eight supervised keypads on

the XR40.

• 16 or 32-character alphanumeric keypads

• 10-zone LED keypads

In addition, the following zone expanders can be added to the XRSuper6/XR20/XR40 panels:

• One, four, eight and 16-zone expansion modules

• Single-zone PIR and glassbreak detectors

• One 738A Ademco Wireless interface for up to 32 points of zone expansion

• One FA426 Wireless receiver for up to 16 points of zone expansion (Two FA426 on the XR40)

When using the FA426 Wireless Receiver, you can add unsupervised devices to address ve of the XRSuper6

and XR20.

1.5 Outputs

The XRSuper6/XR20/XR40 panels provide four open collector outputs rated for 50mA each. A Model 300

Output Harness is required. The open collector outputs provide the ground connection for a positive voltage

source.

1.6 Enclosure Specications

The XRSuper6/XR20/XR40 panel ships in an enclosure with EOL resistors, battery leads, user’s guide, and

programming sheet. All enclosures are constructed using 20-gauge cold rolled steel except where noted.

Model 340 Enclosure

Enclosure size: 12.5” W x 9.5” H x 2.75” D

Color: Gray (G)

Model 349 Enclosure

Enclosure size: 12.5” W x 11.25” H x 3.5” D

Color: Gray (G) or Red (R)

Model 341 Enclosure

Enclosure size: 12.75” W x 6.55” H x 2.9” D

Color: Gray (G)

Model 342 Enclosure

Enclosure size: 11” W x 5” H x 2.75” D

Color: Gray (G)

Model 350A Enclosure

Enclosure size: 17.1” W x 13.2” H x 3.7” D

Color: Gray (G)

Construction: 18-gauge with 16-gauge door

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Security Command XRSuper6 Guide d'installation Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Claviers numériques Security Command XRSuper6