Security Command R500 Guide de l'utilisateur télécharger pdf (Page 29)

In Linux

To manually start the SLP daemon, execute the following command:

installation-directory-for-the-Device-Manager-server/HiCommandServer/wsi/bin/slpd.sh start

To stop the SLP daemon, execute the following command:

installation-directory-for-the-Device-Manager-server/HiCommandServer/wsi/bin/slpd.sh stop

The following shows an example of executing the commands:

# /opt/HiCommand/HiCommandServer/wsi/bin/slpd.sh start

# /opt/HiCommand/HiCommandServer/wsi/bin/slpd.sh stop

Notes on using OpenSLP

The SLP service (or SLP daemon) of OpenSLP outputs operation logs to the

following file:

In Windows:

%WINDIR%slpd.log#

#%WINDIR% is replaced by the value of the environment variable WINDIR in

Windows. Normally, the value is

C:\WINNT\.

In Linux:

installation-directory-for-the-Device-Manager-

server/HiCommandServer/wsi/cfg/slp.log

By default, only the start message at SLP service startup is output to the log

file. Since the SLP service log output (or SLP daemon) accumulates as time

elapses, if you use the SLP service (or SLP daemon) for an extended period of

time, the log output may eventually use up a lot of disk space. To prevent this,

you need to periodically back up the log file and clear the disk space.

Overview and Setup of CIM/WBEM 1-17

Hitachi Device Manager SMI-S Provider Installation and User Guide

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 61 62

Pas de commentaire

Security Command R500 Guide de l'utilisateur Page 29